Adaptive meshing in MWS

Hi all,
In solver setup, we have an adaptive meshing for stable and accuracy improvement!
Let's say if I use the Confinement Strategy "Energy Based" to run a quite complicated model. After some passes, I get a converge condition (Maximum Delta S<0.02, or Port impedance ~ 50ohm), and the meshcell is increased as a results!
I wonder how to use this condition for the next simulation without adaptive meshing! Mean, after modifying structure, I have to run adaptive mesh again that consuming a lot of time before reaching the stable-pass!
Thanks in advance for any help!

In simulating softwares almost every thing is bit tricky. Energy based adaptive mesh increase no. of meshing in those areas where it find high concentration of currents.
Although it offer for next modified structure but its good idea to use mesh adaptation when u r finalizing your results.